Non-woven wipes, tack cloths, pre-saturated wipes and adhesive removers, specified per station in press, body, paint and assembly.
Wipe for the topcoat zone. High absorption rate with no fibre or smear residue, keeping surface cleanliness verifiable under booth lighting.
Pre-wetted microfibre wipe for final cleaning before clear coat, removing fine particles.
General workshop wipe for equipment, tools and spill cleaning, balancing strength and absorbency.
Wipe for the body line. Removes oil and weld dust, abrasion resistant and resistant to tearing on burrs.
Heavier grade for thick oil and sealant residue. Higher absorption per sheet reduces change frequency.
High surface friction for stubborn adhesive and dried soil removal, without shedding.
Pre-cut sheets, taken at the station without tearing from a roll. Consistent format allows metered consumption.
Two ply construction separating absorption and barrier layers. For sealant and adhesive residue, preventing soil from returning to the panel.
Textured non-woven surface adds mechanical action for tape residue and thin sealant films, more efficient with solvent.
Removes uncured sealant without solvent. Reduces chemical handling steps and operator VOC exposure.
General grade covering most workshop cleaning needs. Controlled cost for high frequency consumption.
Wipe meeting aerospace AMS requirements, reducing material segregation where automotive and aerospace share a supply line.
Microfibre cleanroom wipe for robot booths and clean areas. Traps fine particles without scratching high gloss.
Dry tack cloth for removing loose dust before painting. The tack formulation stays on the cloth and does not transfer.
Non-woven tack cloth with higher tensile strength than traditional gauze, allowing a large panel to be wiped in one pass.
Ready to use pre-saturated wipe with uniform loading. Higher consistency than manual solvent dipping.
High absorbency sponge, wringable and reusable. For coolant, cleaning fluid and spill handling.
Cotton gauze used with degreaser for paint pre-treatment. Fibre stays intact, leaving the surface ready for primer.
Protective cover for paint robots. Blocks overspray and mist, easy to change and clean without restricting robot motion.
Sample requests, spray trial support, product selection and volume pricing. Use the form below. Response within two working days.