Crepe, washi and PVC fine line tapes plus masking film, rated to 160 °C with a straight colour boundary and clean release.
High density washi backing with a closed structure that blocks solvent bleed. Holds a defined boundary through a 120°C bake and releases without adhesive residue.
The high temperature member of the washi family. Withstands a 160°C bake and suits masking at the topcoat and clear coat stages without edge lift.
General purpose crepe paper tape, torn by hand. For short bakes below 80°C, plugging holes and holding process documents.
Creped paper sealed against heat and solvent, holding a defined edge under most industrial paints. For a 120°C bake.
High density crepe paper with natural rubber adhesive for critical masking on bodywork and industrial finishing. Holds a sharp edge through a 160°C oven without paint creep.
At 0.2 mm the heavier backing keeps unwind force low, so long runs do not tear. For extended masking lines and higher load holding.
Natural rubber gives higher initial tack and the tape lies flat without curling. For fixing and masking in repair and aftermarket bays.
The blue backing marks out the masking zone visually. 0.12 mm crepe paper with acrylic adhesive for cycles below 80°C and positioning.
Thin PVC with natural rubber adhesive for two-tone body masking in OEM paint shops. The supple backing follows narrow edges and curves with a straight boundary.
PVC fine line tape with acrylic adhesive. Leaves no adhesive shadow and does not yellow under prolonged bake or UV exposure, suited to light coloured bodywork.
At 200% elongation the tape conforms to complex bumper contours without tearing. The dense PVC surface resists paint penetration for a smooth two-tone edge.
Green backing for two-tone painting on plastic parts. Flexible PVC with natural rubber adhesive conforms to the compound curvature of bumpers and trim.
Cloth backing with natural rubber adhesive at 0.29 mm. For masking, holding and hole plugging through a 180°C bake.
Masking film in roll form with a taped edge, applied as it is unrolled. For full body and large area masking, rated 180°C for 45 minutes.
Sample requests, spray trial support, product selection and volume pricing. Use the form below. Response within two working days.